How to program a HomeLink- Car?
Programming HomeLink - Car
- Clear out anything previously programmed into the
in-car system from the factory by holding down on the 2-outside buttons
simultaneously, until the in-car red light starts flashing rapidly. This may
take up to a minute. (In a few cases, some make cars require the keys
to be in the ignition, or the car motor must be running,
or the car door must be shut)
- Decide which button you want to make to be your in-car garage door transmitter. Hold your transmitter up near the selected button, pressing both the garage door remote and the selected in-car transmitter button simultaneously. Hold down on the buttons until the in-car, red light flashes rapidly. this sets the in-car transmitter to be your garage door openers make transmitter, but you are not done. You now need to make this in-car transmitter your personal transmitter.
- Go to the Learn Button on your garage door opener. The button is
usually next to the area where the floppy antenna is connected to the
motor head. With Genie it is most often behind the light lens, and an
indicator light flashes red when pressed. With Sears or Liftmaster
(Chamberlain) it is near, or part of, the terminal screw board, and is
a red, green or purple square button with a green, amber or purple
indicator light. Press this learn button momentarily. The indicator light
will turn on and blink if Genie or otherwise stay lit.
- Go back to the in-car transmitter button you programmed and press this button 3 or 4
times, or until the door starts moving. This should set your in-car
transmitter to your garage door opener.
In Your Cart: 